I turned an ESP32-C6 into a Zigbee coordinator. Here's what tripped me up
-
I've been curious whether a cheap ESP32-C6 board could run a Zigbee network on its own, since it has an 802.15.4 radio built in. Short answer: it can, but there are a few gotchas.
What caught me out
• Zigbee Mode setting: in Arduino IDE you have to set Tools > Zigbee Mode to ZCZR (coordinator/router). If you leave it on End Device, the coordinator sketch won't compile.
• Partition scheme: it needs the matching Zigbee ZCZR partition for your board's flash size. Copying a setting from a tutorial for a different board caused me problems.
• Charge-only USB cable: the board powered on but never showed up as a port. Swapping the cable fixed it.
• Joining vs binding: my test bulb joined fine but didn't respond. The endpoint and binding setup was the real issue, not pairing.
Would I run my house on it?
No. It's a great learning tool and a solid base for a custom gateway. For a permanent Home Assistant network with dozens of devices, I'd still use a dedicated coordinator like a ZBDongle-P or an SLZB-06.
Full walkthrough with the coordinator sketch and a troubleshooting checklist: https://zigbeehubs.com/blog/esp32c6/
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login